Re: Network Config - ColorLaserJet 2605
Hi You can Perform a reset which is mentioned below 1.Turn off the printer.2.Press and hold the (Select) and (Cancel Job) buttons simultaneously.3.Turn on the printer.4.When you see the message...
View ArticleRe: HP Color LaserJet 4600- Will not print multiple copies
Hi, Can we know which drivers you are using, can u please uninstall and try to reinstall the PS drivers. It should fix the issue. RegardsHP
View ArticleRe: Color LJ 2600 streaks
Hi One or more print cartridges might below or defective. If you are using non-HP print cartridges, no messagesappear on the device control panel or on the HP Toolbox.Replace any low print cartridges...
View ArticleRe: Why does it sometimes take forever (many minutes) for each page to print?
The reason for the printer to take many minutes to print each page can have one of the sources below: 1. Print Spooler - may not be spooling the incoming job as expected.2. Print driver - may be...
View ArticleHP Laserjet 6L driver for Windows 8.1 32 Bit
Where can I download a driver which works? I have tried the following drivers for Windows 8.1 32 Bit from the download side:http://www.driverscape.com/download/hewlett-packard-hp-laserjet-6ldriver...
View ArticleRe: HP Laserjet 6Ldoes not work with Windows 8.1
I have posted this Message in revised form again underhttp://h30499.www3.hp.com/t5/Printers-LaserJet/HP-Laserjet-6L-driver-for-Windows-8-1-32-Bit/td-p/6588502#.U_2oP8V_vhkas today is expert day
View ArticleRe: Color Alignment
If calibration doesn't fix the issue, there might be a problem with the ITB or the DC controller.
View ArticleRe: HP M451dn AirPrint Not Working After Firmware Upgrade
Hi ElBobo,Could you check to see if Bonjour is enabled and the printer firewall isn't turned on?In the EWS, choose Networking and click Settings (under Security) to get a list of your network settings....
View ArticleRe: My hp laserjet 6p paper gets jammed each time. the gree lights flashing,...
The only thing I can think of based on the inforamtion you provided is that the pickup roller is probably worn based on the age of the product. I have a couple of things you can try that may help you....
View ArticleRe: 42.B0.01 error on HP M4555 and HP CM4540 running HPAC 12.3
Hi, You may perform a partial clean on both the printers and then reinstall the firmware on both the printers.This should resolve the issue. Although I am an HP employee, I am speaking for myself and...
View ArticleRe: 42.B0.01 error on HP M4555 and HP CM4540 running HPAC 12.3
Are you using HP webjet admin or another job accounting solution in your environment?
View ArticleRe: 2605dn "Non HP supply in use"
In the original case, the printer is behaving as designed. Most customers don't move cartridges from one printer to the next. If a well-used cartridge, that has already reached the 'low' level, is...
View ArticleRe: CM6040f consistent crinkled glossy paper at top of fuser unit.
Hi, The fuser may need to be replaced. Please contact HP Technical support at 1-800-474-6836 to troubleshoot/isolate the issue. Also please do ensure that when you are using the glossy media, the...
View ArticleRe: Have a LJ 4345 that will not recognize some new HP authentic cartridges
You can try the following steps. 1. Turn off the printer.2. Remove the cartridge from the printer.3. Turn on the printer.4. When prompted, install the cartridge and check. Hope this helps... Although...
View ArticleRe: HP Laserjet 1000 - is it compatible with Windows 8??
Hi, As the previous poster pointed out the LaserJet 1000 is not supported by Windows 8.x but I have been looking around for a solution to your request and found that some people have had luck when...
View ArticleRe: Question re: HP Color LaserJet 3800n
Hi Donald, Yes it is and you can use the Postscript HP Universal Print Driver located here:HP Universal Print Driver for Windows PostScript And yes it should print at 600 dpi. (I believe the Print...
View ArticleSlow M880
Hi, I have been involved in quite a few setups and continuing support of the new M880 Machines.Pretty much across the board i have recieved and continue to recieve complaints about how slow the machine...
View ArticleRe: Slow M880
Hi, It was observed that, sometime, Network settigns and application also plays a role in the slow Scanning / Pritning issue. Would be ood to check the network settings option in the Administrative tab...
View ArticleGetting a lines of cramped wingdings instead of printing
Hello gang, A few days ago, I had a user printing "gibberish" from his local printer. This gibberish turned out to be a multitude of pages containing a line or two of cramped wingdings. A colleage told...
View ArticleDevice Error in hp Laserjet 3030 All in one, how to clear it?
My hp Laserjet 3030 AIO is having problem. When I switch on for printing, it displays Device error and continue as if it is trying to print document, till iI switch off. My OS is windows vista home...
View Article