Re: HP CP 3505DN - Printing bad with multiple different toner cartridges
We were able to swap the Black and the Cyan and the problem follows the slot not the cartridge. We have a working transfer belt from another printer so we swapped that out and the problem still exists....
View ArticleP2035 will only display toner missing and attention lights
So far we have 3 of these printers in district that suddenly stopped working. When the printers are turned on they do not cycle gears, or show any other signs of booting. They immediately display just...
View ArticleRe: 2550n thumping then progressively less colours on multi-page document and...
Hi David Thanks for the prompt reply. The manual did say it was an issue and to ensure the white arm was fully up before replacing the cog. I definitely pulled the white arm up as far as it would go...
View ArticleRe: HP LASER JET 3015 SHOWING ERROR 51.10
This is a duplicate, please reply in the following topic:http://h30499.www3.hp.com/t5/Printers-LaserJet/HP-LASER-JET-3015-SHOWING-ERROR-51-10/m-p/6356983
View ArticleRe: P2035 will only display toner missing and attention lights
Have you check the chip on the cartridge and the the sensor that detects it?The chip could be out of position and not being detected.
View Article3015 Tray selection
Probably a basic knowledge issue but I don't know. How do I set up the 3015dn printer so that tray 2 always prints 8.5 by 11 and tray 3 prints 8.5 by 14 and if one tray runs out it doesn't go to the...
View Article3015 Feeding Issues
I am using the HP 3015 and although I also have phantom jams that is not my concern right now. Currently when the printer attempts to print something both of the paper trays attempt to feed causing a...
View ArticleRe: 3015 Tray selection
Hello, in the paper handling settings you can set the trays to plain 8 1/2 x 11(tray 2), and 8 1/2 x 14(tray 3). As for the other question if you go into the configure device menu, system setup, tray...
View ArticleRe: 3015 Feeding Issues
Hello, tray turning off the manuel feed setting, to see if anything changes. Also, I would go into paper handling settings and change tray 1 to another paper type and size. Hope this helps.....
View ArticleHP 2035 FEEDS TWO SHEETS IN A ONE PAGE PRINT
WHAT HAPPENS IS THE PRINTER FEEDS TWO WHITE PAGES WHEN IT ACTUALLY IS PRINTING A ONE PAGE DOCUMENT.
View ArticleHP 2035 FEEDS TWO SHEETS IN A ONE PAGE PRINT
THE PROBLEM IS PRINTER FEEDS 2 PAGES IN A 1 PAGE DOCUMENTS IN TRAY 1. IT PRINTS THE DOCUMENT IN THE FIRST ONE AND THE SECOND PAGE COMES WHITE, IT CAUSES PROBLEMS WITH A LARGE DOCUMENT BECAUSE THERE...
View ArticleRe: HP 2035 FEEDS TWO SHEETS IN A ONE PAGE PRINT
You need to order and then install the part in the link below:http://www.precisionroller.com/paper-feed-components-for-hp-laserjet-p2035/details_63194.html
View ArticleRe: 3015 Feeding Issues
You problem is common on this model. Changing settings will not help. On the right side there is a solenoid with a L arm that prevents the tray 1 roller from turning until the printer knows to use tray...
View ArticleRe: 2550n thumping then progressively less colours on multi-page document and...
Should not be but if to thick and could impede the movement of the carousel. Using a velcro strip usually works better. If the carousel moves from one color to another when you need to replace the...
View ArticleRe: 3015 Feeding Issues
Tray 1 solenoid might be dislocated for your device and same needs to be fixed again by a service tech. To avoid recurrence of this issue, do not open/operate the toner access door while Tray 1...
View ArticleRe: PCL XL Error
I have aHP LaserJetP3015impressoraa,I installeda PCwithwindows 8toimprirofthe following errorPCLXLerrorSubsystemUSERSTREAMErrorMissinDataoperatorReadImagePosition30
View ArticleRe: 2550n thumping then progressively less colours on multi-page document and...
Thanks David, The drum is not moving at all at the moment. It tries to do the normal start up process which involves rotations and various noises but it gets no further than what seems to be a failed...
View ArticleHP P4515x letterhead duplex bug
Hi, I have a HP P4515x which has an issue with any tray with letterhead paper installed. It prints a duplex copy even if not selected. The printer has the latest firmware and the fault occurs even on...
View ArticleRe: HP P4515x letterhead duplex bug
Setting of Alternative Letterhead Mode may be relevant?
View ArticleRe: P2035 will only display toner missing and attention lights
Chips seem okay, there are three printers and several cartridges to swap between each, but all come up the same. Took out the formatter board and baked it @ 400 for 5 mins. No luck.
View Article