We are trying to enable a LaserJet 600 M603 printer on our HP-UX 11iv3 server. The server is using hppi 10.34 version to setup queue. We are using the latest net_ljM603 modelscript and the latest firmware on printer version 2300331_377983.
We use the following command on HP-UX
lp -dCOMM_L2 test_print_file
lpstat -t gives us
printer COMM_L2 now printing COMM_L2-2032. enabled since Dec 27 06:45
fence priority : 0
COMM_L2-2032 root priority 0 Dec 27 07:58 on COMM_L2
test_print_file 321 bytes
This never goes away until we do a cancel on HP-UX (also Windows users print job do not print until we do the HP-UX cancel)
cancel COMM_L2-2032
The printer log file has the following
Dec 27 07:58:45%%[ status: Job: COMM_L2-2032; User: root ]%%
Dec 27 07:58:45%%[ status: making connection to 64.72.28.237; source: ethernet ]%%
Dec 27 07:58:45%%[ status: connected to 64.72.28.237; source: ethernet ]%%
Dec 27 07:58:45%%[ status: transmitting data ]%%
Dec 27 07:58:45%%[ status: finish sending print data ]%%
Dec 27 07:58:57%%[ status: printed 1 pages ]%%
Do not see the end of job message in log file.
Here is the HP-UX queue info
Options: Current Settings:
-------- -----------------
1) Default Queue [NO]
2) Status Log [/opt/hpnpl/tmp/COMM_L2.log]
3) Network Address [64.72.28.237]
4) Additional printer changes . . .
Modelscript used for this queue is net_ljM603
Options: Current Settings:
-------- -----------------
1) Job Recovery [ON]
2) True End-of-Job [ON]
3) Banner Page [OFF]
4) Default Printing Language [AUTO]
5) PostScript Level [Level 3]
6) Banner Tray [2]
7) Banner Paper Size [default]
8) Duplex print [default]
I can ping the printer, telnet to the printer and run tests successfully.
Is there something I have configured wrong to make the printer say it finished the job?
Larry