Re: laserjet 4650 dn - help - blank screen but printer warms up?
thanks for your post. I have ordered a formatter
View ArticleRe: NVRAM initialization, Reset Password, Enable Direct Ports P3005DN
Oldscout,I do this:1. Turn the device off.2. Turn the device on. When the memory count begins, press and hold the button. Continue holdingdown the button until all three device control-panel lights...
View ArticleRe: NVRAM initialization, Reset Password, Enable Direct Ports P3005DN
Thanks for the link, The IP adress is 0.0.0.0What else can I do. It is control panel password protected.
View ArticleRe: HP LaserJet 2430 model Q5964A Only prints from the Manual feed
You need to set tray 2 for plain paper. Extra heavy paper will only feed through tray one.
View ArticleRe: Users unable to change output bin
I believe that the desired results could be achieved by multiple ways, hence would like to privide my inputs as following. Do check if the 3000 sheet stacker accessory is recognised/configured for the...
View ArticleRe: Disable the Paper Size Mismatch Error
I have seen this, try setting try 2 to any type any size.I do not work for HP but I do work on them.
View ArticleRe: NVRAM initialization, Reset Password, Enable Direct Ports P3005DN
Is the printer still connected to the network when you do this?If so disconnect it and try again.The only password related issue I can find is the network setting pass word. Your only other course of...
View ArticleRe: HP LaserJet Pro 400 Color M451dn: problem installing driver
I too am having the same issue, I followed #12, same error. I am on a Win 7 Pro system and ran the install as administrator - No Luck. I called HP support and spoke to the over the pond support who...
View ArticleRe: HP laserjet 1200
What happens when you press the go button? It should print a self test. Are any lights on? If it does not print a self test. you have a problem a technician should look at. If it prints go to printers...
View ArticleRe: HP Color LaserJet CP4525 5/6 E/F
I tried the following steps the printer is still stuck at that screen. any other ideas? thanks for your help.
View ArticleRe: HP Color LaserJet CP4525 5/6 E/F
How can i load the new firmware with the printer being stuck at that screen? when i connect the printer to my PC it does not see it because the printer is not botting up? the printer was a network...
View ArticleRe: HP Color LaserJet CP4525 5/6 E/F
As described earlier, it might be an error caused due to corrupt formatter firmware (accessory firmware in some cases, hence disconnecting accessories was suggested). You might need to replace the...
View ArticleRe: LaserJet 1320 Not Printing Multiple Copies Anymore
Thanks for the solution although I am still a bit puzzled. I upgraded the memory in my LaserJet 1320 to its max of 128mb and even with that it would still only print a single copy (3 pages). Oh well I...
View ArticleRe: HP Color LaserJet CP4525 5/6 E/F
The print do not have anything attached to it. Is that what you mean when you say accessories? No extra tray or anything is on it. Just the basic tray that came with the printer.
View ArticleRe: Laserjet 1320 pulls 2 sheets of paper
Hello comput, It is most likely to be a hardware issue related to Tray 2 Solenoid and in a very rear case the engine controller. Try printing the same job from Tray 1 and check the results.
View Articlelaserjet 600 - prints odd charcters at top page and nothing else
i have just installed a new laserjet 600 Some pages print correctly, whilst others just come out with random odd charcters at the top I print forms from a dbase for orders, it is set to print 1 form...
View ArticleRe: laserjet 600 - prints odd charcters at top page and nothing else
Down load the latest driver for HP And re install the Printer.You have no idea how old the drivers are on the cd.
View ArticleRe: laserjet 600 - prints odd charcters at top page and nothing else
thanks - do i need to download the full software solution from the HP site or just the drivers?
View Article