Re: HP LaserJet P3005
Looks like a possible transfer roller. Has the formatter been disconnected lately? Make sure the ribbon cable is seated properly on it.
View ArticleRe: HP LaserJet P3005
Nothing has been disconnected except that I used a HP Q7812-67905 Kit-110V Fuser maintenance kit.I replaced everyhting that came with the kit and it is doing the same thing as before. I then replaced...
View ArticleRe: HP LaserJet P3005
You have a repetitive defect. Maasure the distance between 2 lines.
View ArticleRe: HP LaserJet P3005
The closest would be 38mm which is the primary charge roller found in the toner cartridge. If you have changed toner cartridges check the HV contacts on the left side of the printer for any defects.
View ArticleRe: HP LaserJet P3005
everything looks clean, I pulled cartridge out and brushed off the contacts.
View ArticleRe: HP LaserJet P3005
Well its either a toner issue or a voltage issue. High voltage that is. Might want to wait for any other recommendations.
View ArticleRe: HP LaserJet P3005
OK, thanks. I appreciate your assistance. It has been doing this for a while, I just got tired of it and decided to try to fix it. My co-workers told me to print to another network printer, but I don't...
View ArticleRe: 13.1 error with new rollers
DavidZuts, you helped me fix my issue in another thread I found of yours. Turns out it was the solenoid on the right side of the printer that controls the pickup roller in the tray. I just had to clean...
View ArticleRe: HP Color LaserJet 1600N colors out of alignment.
Thanks, This printer doesn't seem to thave the reset mode. I've tried every possible combination of pushing, holding, and power cycling I can think of, and all I get is another test page.
View ArticleRe: laserjet M1132
Hello MaxKindermann, We would like to encourage that this discussion should be continued in English language as this forums is a English construct-based communities as per the rules of participation...
View ArticleRe: Laserjet 4050 prints blank pages after cleaning
Thanks Annie, but it says IE cannot display the webpage. Thanks anyway.
View ArticleRe: Laserjet 4050 prints blank pages after cleaning
Thanks David. I tried to open the front cover by following the online service manual chapter 6 but was stuck at 6-11. Not surprising for this old dummy. They all look so complicated to me. Will see...
View ArticleHP LaserJet Pro 200 Color MFP M276nw, how to Double Side Print
I have this HP LaserJet Pro 200 Color MFP M276nw, how to Double Side Print automatically?
View ArticleRe: Laserjet 4050 prints blank pages after cleaning
>it says IE cannot display the webpage. I have no problems with IE10 nor firefox 29.0.1.
View ArticleRe: HP Laserjet 1200 print settings
Thanks for your prompt reply Chris How do I [or perhaps you!] chnage the pitch from 12 to 16.67 as I will need to print in that size in order to print reports in Foxbase+ in Dos. And then I am not...
View ArticleRe: HP Laserjet 1200 print settings
>> ... chnage the pitch from 12 to 16.67 ... Change the value 12 in the original sample file to 16.67 - I've done this for you in the attached new sample file. >> ... not clear as to HOW I...
View Article