Hi,
I've been asked to fixed an issue of printing to a UB-04 Form correctly. Through my research many people have had issues on all types of lasers printing to this form. After a bit of searching I noticed a note about this issue from a website with some parameters but am not sure where to change some of these parameters, and I'm not sure if this will work.
So has anyone figured out how to print correctly to this form?
The first printout is very close but the top of the print just about touches the top line of the box. As you print out the 2nd anf 3rd sheet the print moves up but then stays there.
Below are the paramenters that I found and I saw a plase in the firmware under gerneral settings, administrative console, and then finally PCl where I could input some of these settings. When I tried by inputting different text lengths the firware took and accepted the inut but when printing the output was not affected. Forexample, I tried the number 50 , the number 70 but the length did not change.
Here's what I've found so far and it wasn't for a M602 but another laserjet:
oreientation: Portrait
Paper Size: Letter
CPI: 10.05
Left Margin: 0.20 inches (where do I adjust this?)
LPI: 6.0 (where do I adjust this?)
Top Margin: 0.095 (where do I adjust this?)
Text Len: 64 lines
So what I'm looking for are:
- the correct parameters
- Where do I input them
- Why didn't my test of different text lengths work
I know there will be some questions but I'm close but not there yet.
Thanks
Steve