Hope David is still around or someone with as much knowledge!!!
Had the 10.92.00 error and this is what I have figured out, and what I need assistance with.
I took all ink out and shut...reset and stated needed supplies.
After troubleshooting, I realized I could install 1 and up to 3 successfully then either the 3rd or final 4th ink cartridge installed and same error.
Realize that once I opened and installed the remaining cartridges it was not locking them in place. Taking all out and starting over seemed to work until I "overloaded" the locking mechanism with to many cartridges?
Is there a gear that could be missing teeth to cause this, or what might be a cause?
Any help would be greatly appreciated! And thank you in advance.!!!
Thanks,
Shawn